MDF Production

Appearance (TS 1770)

Products manufactured using MDFLam coating should be free of protrusions and depressions. There should be no manufacturing or cutting defects at the edges and corners.

Deviation from Shape and Squareness (TS 1770)

MDFLam must be in the shape of a rectangular prism, with its corners intersecting at right angles. For a side length of 1000 mm, the deviation from the square edge should not exceed 2 mm.

When the width and length exceed 1000 mm, the deviation must remain within the width and length tolerance limits.

Dimensions and Tolerances (TS 1770)

The length and width of MDFLam products are unrestricted, provided they conform to the module dimensions in TS 2014 and TS 2018. The thickness must not be less than 1.5 mm for wood fiber products and 6 mm for particle board products. The thickness tolerance for MDFLam products is: ± 0.2 mm, width tolerance: ± 3 mm, length tolerance: ± 5 mm.

Physical and Mechanical Properties (TS 1770)

The physical and mechanical properties of products manufactured as MDFLam must conform to the values given in the table.

Marking (TS 1770)

The company's registered trademark or abbreviated name, the TS 1770 mark (TM), the name and type of the plate, the nominal dimensions of the plate (thickness, length, width) in mm, and in the case of packaged sales, in addition to these, the color and pattern of the plate, whether one or two sides are coated, the type, and the number of plates in the package are written on the packaging.

Packaging (TS 1770)

To prevent MDFLam panels from falling apart during packaging, their edges must be strapped lengthwise and widthwise with banding, and MDFLam sections are cut at the points where these bands meet.